BURMAN CP CLUTCH

This is the older model of the small clutches. The bonded plate has small outer lips that pass through the clutch basket. Many pre war makes use this. About 1952 it was replaced by the B52 clutch.

CLUTCH ROLLER 1/4" X 5,95MM 57-0394 ! Typical Triumph clutch roller. Fits all twins 1938-1985 You need 20x per bike Also used on BSA A50/65; BSA number: 42-3206 Burman CP  clutch uses the same 24x

CLUTCH BEARING RACE CENTRE BUR12-10-2 ! Fresh production. 30,2mm x 42,65mm x 1/4"

TAB WASHER BUR12-7-5 !

ADJUSTER NUT FOR CLUTCH SPRING BUR23-X-3 ! Old number 11-2-2

CLUTCH PUSH ROD 9 7/8" CP 4-plate BUR28-X-56 !

CLUTCH PUSH ROD 10 1/16" CP 5-plate BUR28-X-57 !

CLUTCH SPRING BUR36-6-1 !

CLUTCH PLATE CP BUR3-X-2 ! CP clutch plate.

2MM STEEL PLATE FOR CP AND B52 BUR5-X-1/2 ! Outer diameter 139,9mm 2mm thick

CLUTCH HUB/SLEEVE FOR MAINSHAFT BURG35-2 ! Fits both CP and B52 clutches. When you replace the clutch centre, don't forget this one.